Honda 2008 Element Owner's Manual page 207

Main Menu
2. Remove the electrical connector
from the bulb by pulling the
connector straight back.
3. Remove the rubber weather seal
by pulling on the tab.
4. Unclip the end of the hold-down
wire from its slot. Pivot the wire
out of the way, then remove the
bulb.
Table Of Contents
5. Install the new bulb into the hole,
making sure the tabs are in their
slots. Pivot the hold-down wire
back in place, and clip the end into
the slot.
6. Reinstall the rubber weather seal.
Make sure it is right side up; it is
marked ''TOP.''
Push the electrical connector onto
7.
the new bulb. Make sure it is
connected securely. Turn on the
headlights to test the new bulb.
8. (Driver's side)
Install the front end of the air
intake duct.
2008 Element
On SC model
AIR INTAKE DUCT
The high beam headlight bulb and
the low beam headlight bulb are
replaced the same way.
1. Open the hood.
If you need to change the
headlight bulb on the driver's side,
remove the front end of the air
intake duct by pulling it out.
Lights
CONTINUED
203