Transmission Fluid; Automatic Transmission Fluid - Honda 2008 Element Owner's Manual

Main Menu

Transmission Fluid

Automatic Transmission Fluid

Check the fluid level with the engine
at normal operating temperature.
1. Park the vehicle on level ground.
Start the engine, let it run until the
radiator fan comes on, then shut
off the engine. For accurate
results, wait about 60 seconds (but
no longer than 90 seconds) before
doing step 2.
DIPSTICK
2. Remove the dipstick (yellow loop)
from the transmission, and wipe it
with a clean cloth.
198
Table Of Contents
HOT
MARK
3. Insert the dipstick all the way into
the transmission securely as
shown in the illustration.
4. Remove the dipstick and check
the fluid level. It should be
between the upper and lower
marks.
2008 Element
5. If the level is below the lower
mark, add fluid into the dipstick
hole to bring it to the level
between the upper and lower
marks.
Pour the fluid slowly and carefully
UPPER
so you do not spill any. Clean up
MARK
any spill immediately; it could
LOWER
damage components in the engine
MARK
compartment.
Always use Honda ATF-Z1
(automatic transmission fluid).