Table of Contents
Advertisement
Don't use any of these unless this manual says you can.
In many uses, these will damage your vehicle:
0
Alcohol
Laundry Soap
Bleach
Reducing Agents
Cleaning the Inside of Your Vehicle
Use a vacuum cleaner often to get rid of dust and loose
dirt. Wipe vinyl or leather with a clean, damp cloth.
Your GM dealer has two cleaners, a solvent-type spot
lifter and a foam-type powdered cleaner. They will clean
normal spots and stains very well. Do not use them on
vinyl or leather.
Here are some cleaning tips:
1.
Always read the instructions on the cleaner label.
2. Clean up stains as soon
as you can -- before they set.
3. Use a clean cloth or sponge, and change to
a
clean
area often. A soft brush may be used if stains
are stubborn.
4. Use solvent-type cleaners in a well-ventilated area
only. If you use them, don't saturate the stained area.
5 . If a ring forms after spot cleaning, clean the entire
area immediately or it will set.
Using Foam-Type Cleaner on Fabric
1 . Vacuum and brush the area to remove any loose dirt.
2. Always clean
a
whole triln panel or section. Mask
surrounding trim along stitch or welt lines.
3. Mix Multi-Purpose Powdered Cleaner following the
directions on the container label.
4. Use suds only and apply with a clean sponge. Don't
saturate the material and don't rub it roughly.
5 . As soon as you've cleaned the section, use
a
sponge
to remove the suds.
6. Rinse the section with a clean, wet sponge.
7. Wipe off what's left
with a slightly damp paper towel
or cloth.
8. Dry
it
immediately with a blow dryer.
9. Wipe with a clean cloth.
6-53
Advertisement
Table of Contents
