Table of Contents
Advertisement
Cleaning the Inside of Your Vehicle
Use a vacuum cleaner often to get rid of dust and loose
dirt. Wipe vinyl or leather with a clean, damp cloth.
Your CM dealer has two GM cleaners, a solvent-type
spot lifter and a foam-type powdered cleaner. They will
clean normal spots and stains very well. Do not use
them on vinyl or leather.
Here are some cleaning tips:
Always read the instructions on the cleaner label.
Clean up stains as soon as you can -- before they set.
Use a clean cloth or sponge, and change to a clean area
often. A soft brush may be used if stains are stubborn.
Use solvent-type cleaners in a well-ventilated area
only. If you use them, don't saturate the stained area.
If a ring forms after spot cleaning, clean the entire
area immediately or
it
will set.
Using Foam-Type Cleaner on Fabric
1.
2.
3.
4.
5.
6.
7 .
8.
9.
10.
11.
Vacuum and brush the area to remove any
loose dirt.
Always clean a whole trim panel or section.
Mask surrounding trim along stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner following
the directions on the container label.
Use suds only and apply with
a
clean sponge.
Don't saturate the material.
Don't rub it roughly.
As soon as you've cleaned the section, use a
sponge to remove the suds.
Rinse the section with a clean, wet sponge.
Wipe off what's left with a slightly damp paper
towel or cloth.
Then dry
it
immediately with
a
blow dryer.
Wipe with a clean cloth.
6-51
Advertisement
Table of Contents
