Table of Contents
Advertisement
Removing the Rear Seat
I . Disconnect the quick release latch plates for the lap
shoulder belts on the bench seat to be re~noved. To
do
this, press the tip of a key into the
elea ease
hole of
the safety belt end release buckle while pulling up on
the safety belt.
2. At the floor, rell~ove the plastic trim covers i n front
of and behind the seat supports.
3. Lift up on
the latch lever located at the front of
each seat support. The latch lever will stay in the
up position.
4. Roll the seat toward the open slots in both rails. Lift
the seat up and out of both rails.
5. Remove the seat from the vehicle.
6.
Install long trim covers
t o
the front portion of the
floor rails.
1-6
Advertisement
Table of Contents
