Advertisement
Feature Locations
NFB Short Breaker
ON
OFF
Max.Amps
Display Panel
Over current
No Appliance connected
Over 15A Max Current
Defect Detect
Out of Range Voltage
Surge Protection Ready
Grounded Correct
Line、Neutral Wired Correct
Quick Start Guide:
Use these quick start instructions to get up and running in just a few minutes. Be sure to review all the operating
instructions later to ensure full enjoyment of the product.
1. Connect the Kill A Watt™ PS unit to the outlet and the appliance to the unit.
2. The LCD display will flash. Press any of the function keys to stop the flashing.
3. Press the OFF key. The OFF key will illuminate red.
4. Press the ON key. The ON key will illuminate green and the attached appliance will be powered.
5. If the attached appliance is turned off and is not consuming any power, the unit will detect no load. The
ON key will go dark and the "NO Load" icon will flash on the LCD display. THIS IS NORMAL. If the
attached appliance is then turned on, the unit will detect a load, the ON key will illuminate and the "NO
Load" indicator on the LCD display will disappear.
6. Pressing the Volt/Amp key will cycle through currently measured voltage (Volts), current (Amps) and
Maximum/Minimum measured values.
Shop for P3 products online at:
Watt/PF
Volt/Amp
Up to date Max.
Over
Current
NO Load
Over Load
REPLACE
Abnormal
Voltage
Up to date Min.
PowerMeterStore
www.
Elapsed Time
KWH/Leakage
Volt
Watt
MAX
Amp
MIN
%
Surge
Ground
Wiring
OK
OK
OK
10 Normal Outlets
AC Voltage
AC Power
Kilo - Watt - Hour
Elapsed Days
KWH
Day
AC Current
mA
Leakage Current
Hour
Elapsed Hours
Power Factor
1.877.766.5412
.ca
Advertisement
