Gigabyte TRX40 AORUS XTREME User Manual page 30

10) LED_C1/LED_C2 (RGB LED Strip Headers)
The headers can be used to connect a standard 5050 RGB LED strip (12V/G/R/B), with maximum power
rating of 2A (12V) and maximum length of 2m.
For how to turn on/off the lights of the LED strip, refer to the instructions on in Chapter 5, "Unique
Features," "APP Center\RGB Fusion."
Before installing the devices, be sure to turn off the devices and your computer. Unplug the power cord
from the power outlet to prevent damage to the devices.
11) NOISE_SENSOR (Noise Detection Header)
This header can be used to connect a noise detection cable to detect the noise inside the case.
For more information on the noise detection function, refer to the instructions in Chapter 5, "Unique
Features," "APP Center\System Information Viewer."
Before connecting the cable to the header, make sure to remove the jumper cap; re-place the
jumper cap if the header is not in use.
Hardware Installation
DEBUG
PORT
Pin No. Definition
1
RGB LED
Strip
Connect one end of the RGB LED strip exten-
sion cable to the header and the other end to
your RGB LED strip. The black wire (marked
with a triangle on the plug) of the extension
cable must be connected to Pin 1 (12V) of this
header. The 12V pin (marked with an arrow)
1
on the other end of the extension cable must
12V
be lined up with the 12V of the LED strip. Be
careful with the connection orientation of the
LED strip; incorrect connection may lead to the
damage of the LED strip.
1
- 30 -
1 12V
2 G
3 R
4 B
Pin No. Definition
1 Noise detection
2 GND
Noise detection
cable
1