Battery Replacement; Remote Vehicle Start - Chevrolet 2009 Cobalt Owner's Manual

Hide thumbs Also See for 2009 Cobalt:
Table of Contents

Advertisement

Battery Replacement

Replace the battery if the KEY FOB BATT LOW
message displays in the DIC. See "KEY FOB BATT
LOW" under DIC Warnings and Messages on page 3-46.
Notice: When replacing the battery, do not touch
any of the circuitry on the transmitter. Static from
your body could damage the transmitter.
To replace the battery:
1. Separate the transmitter with a flat, thin object
inserted into the notch on the side.
2. Remove the old battery. Do not use a metal object.
2-6
3. Insert the new battery, positive side facing up.
Replace with a CR2032 or equivalent battery.
4. Snap the transmitter back together.

Remote Vehicle Start

Your vehicle may have a remote start feature.
This feature allows you to start the engine from outside
the vehicle. It may also start the vehicle's heating or
air conditioning systems. When you start your vehicle
using the remote start feature, the climate control
system will come on and adjust the interior to the
temperature settings that you left it set to when you
turned the vehicle off.
Laws in some communities may restrict the use of
remote starters. For example, some laws may require a
person using remote start to have the vehicle in view
when doing so. Check local regulations for any
requirements on remote starting of vehicles.
Do not use the remote start feature if your vehicle is low
on fuel. Your vehicle may run out of fuel.
The remote start feature provides two separate starts
per ignition cycle, each with 10 minutes of engine
running time.
After your vehicle's engine has been started two times
using the remote vehicle start button, the vehicle's
ignition switch must be turned to ON/RUN and then back
to LOCK/OFF using the key before the remote start

Advertisement

Table of Contents
loading

Table of Contents