Playing The Radio - Chevrolet 2009 Cobalt Owner's Manual

Hide thumbs Also See for 2009 Cobalt:
Table of Contents

Advertisement

Playing the Radio

O
(Power/Volume): Press to turn the system on and
off. Turn to increase or decrease the volume.
Speed Compensated Volume (SCV): Radios with
the Speed Compensated Volume (SCV) feature
automatically adjust the radio volume to compensate for
road and wind noise as the vehicle speeds up or slows
down, so that the volume level is consistent.
To activate SCV:
1. Set the radio volume to the desired level.
2. Press MENU to display the radio setup menu.
3. Press the softkey under the AUTO VOLUM tab on
the radio display.
4. Press the softkey under the desired Speed
Compensated Volume setting (OFF, Low, Med,
or High) to select the level of radio volume
compensation. The display times out after
approximately 10 seconds. Each higher setting
allows for more radio volume compensation at faster
vehicle speeds.
3-62
Finding a Station
BAND: Press to choose between FM1, FM2, AM, or
XM™ (if equipped) on the Radio with CD (Base).
Press to choose between FM, AM, XM (if equipped) on
the Radio with CD (MP3) and USB Port or the Radio
with CD (MP3).
f
(Tune): Turn to select radio stations.
©
SEEK: Press to seek or scan stations with a strong
signal in the selected band.
To seek stations, press and release
to the previous station and stay there.
To scan stations, press and hold
few seconds until the radio beeps once. The radio
goes to a station, plays for a few seconds, then
goes to the next station. Press
stop scanning.
To scan preset stations in the selected band,
©
press and hold
SEEK for four seconds until
a double beep sounds. The radio goes to a stored
preset, plays for a few seconds, then goes to
the next stored preset. Press
stop scanning preset stations.
©
SEEK to go
©
SEEK for a
©
SEEK again to
©
SEEK again to

Advertisement

Table of Contents
loading

Table of Contents