Sunroof - Chevrolet 2008 Tahoe Owner's Manual

To put the cover in the vehicle, do the following:
1. Make sure the cover slot in the holder faces
rearward with the round surface facing down.
2. Then, hold the cover at an angle and place the
cover end cap into the slot in the passenger's
side trim panel.
3. Move the other end of the cover forward and hold it
next to the driver's side trim panel slot.
4. Press the end caps in, this will allow the cover to
fit into the trim slot.
5. Lightly pull on the cover holder to make sure it is
secure.
On the extended wheelbase models there are
two cover positions. The slots furthest forward allow
the cover to be used if the third seat is removed
or folded down. The cover can be installed
and removed from either side.
Cargo Tie Downs
Your vehicle may have cargo tie downs in the rear
cargo area that allow you to strap cargo in and keep it
from moving inside the vehicle.
2-74

Sunroof

Your vehicle may be equipped with a power sliding
sunroof. To open or close the sunroof, the ignition needs
to be turned to ON, or Retained Accessory Power (RAP)
must be active. When RAP is active, the sunroof will work
for 10 minutes after the ignition is turned off, or until a
front door is opened. See Retained Accessory Power
(RAP) on page 2-27 for more information.
Manual-Open/Manual-Close: To open the sunroof
press and hold the rear of the driver's side switch until
the sunroof reaches the desired position. To close
the sunroof, press and hold the front of the driver's side
switch until the sunroof reaches the desired position.
The sunshade will open automatically with the sunroof,
but can also be opened manually.
There are two switches in
the overhead console that
operate the sunroof.