Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer; Flash-To-Pass - Chevrolet 2008 Equinox Owner's Manual

Turn and Lane-Change Signals

The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will return
automatically.
To signal a lane change, raise or lower the lever until
the arrow starts to flash. Hold it there until you complete
the lane change. The lever will return by itself when
you release it.
As you signal a turn or a lane change, if the arrows
flash rapidly, a signal bulb may be burned out and other
drivers won't see your turn signal.
If a bulb is burned out, replace it to help avoid an
accident. If the arrows do not go on at all when you
signal a turn, check the fuse, see Fuses and Circuit
Breakers on page 5-100 and for burned-out bulbs.
3-8
An arrow on the instrument
panel cluster will flash in
the direction of the
turn or lane change.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high,
push the turn signal lever away from you. To change
from high beam to low beam, pull the turn signal
lever towards you. To flash the high beams from low
beam, pull the turn signal lever all the way towards you.
Then release it.

Flash-to-Pass

This feature lets you use your high-beam headlamps to
signal a driver in front of you that you want to pass.
To flash the high beams from low beam, pull the turn
signal/multifunction lever all the way towards you.
Then release it.
When the high beams
are on, this light on the
instrument panel cluster
will also be on.