MSI MS-6137 User Manual page 49

Micro-atx wh1 mainboard

Hide thumbs Also See for MS-6137:

Table of Contents

CHAPTER 3

IDE HDD Block Mode

Block mode is also called block transfer, multiple commands, or

multiple sector read/write. If your IDE hard drive supports block mode (most

new drives do), select Enabled for automatic detection of the optimal number

of block read/writes per sector the drive can support. The settings are:

Enabled, Disabled.

Power On Function

This function allows you to select the item to power on the system.

The settings are : Button Only, Mouse Left, Mouse Right, Password,

Hotkey, keyboard 98.

Onboard FDC Controller

Select Enabled if your system has a floppy disk controller (FDD)

installed on the system board and you wish to use it. If you install add-on

FDC or the system has no floppy drive, select Disabled in this field.

The settings are: Enabled and Disabled.

Onboard Serial Port 1/Port 2

Select an address and corresponding interrupt for the first and

second serial ports. The settings are: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/

IRQ3, Disabled, Auto.

UART Mode Select

This item allows you to determine which InfraRed(IR) function of the

onboard I/O chip, this functions uses.

AWARD

3-18

BIOS SETUP

Table of Contents

Ms-6137 v3