Table of Contents
Advertisement
NOTE:
Always have a qualified service technician perform difficult conversions or modifications.
WARNING:
Never attach an unregulated gas line to the appliance. Connection to an
unregulated gas line can cause excessive heat or fire.
Before connecting appliance to gas source, make sure control knobs are in "OFF"
IMPORTANT:
position.
Verify the type of gas supply to be used, either Natural Gas or LP (Propane), and make sure the
marking on the appliance rating label agrees with that of the supply.
All pipe sealants must be an approved type and resistant to the actions of LP gas. Never use pipe
sealant on flare fittings. The installation of this appliance must conform with local codes or, in the
absence of local codes, with either National Fuel Gas Code, ANSI Z223.1/ NFPA 54, Natural Gas and
Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2, or the
Standard for Recreational Vehicles, ANSI A 119.2/ NFPA 1192M, and CSA Z240 RV Series,
Recreational Vehicle Code, as applicable.
WARNING:
Gas valves are preset at the factory to operate on LP or natural gas. If you wish to convert,
be sure to contact your dealer FIRST!
LP Gas Hook-up
This propane gas appliance is designed to operate on propane gas ONLY, at a pressure regulated at
11" water column (W.C.) when equipped with the correct propane orifices on the valves and a propane
regulator on the supply line regulated at the residential meter. The LP gas appliance is designed to be
used with a standard 20 lbs. gas cylinder that must be constructed and marked in accordance with
specifications of the US Department of Transportation for propane gas cylinders.
Always keep cylinder securely fastened in an upright position. Never connect an unregulated propane
gas cylinder to the appliance.
Do not subject propane cylinders to excessive heat.
CAUTION:
Never store an LP gas cylinder inside a building or in the vicinity of any gas-burning
appliance.
Cylinder Specifications
-
Any LP gas supply cylinder used with this appliance must be
approximately 12 inches diameter and 18 inches high. The maximum
fuel capacity is 80% and is approximately 20 pounds of propane.
-
The LP cylinder must have a shut-off valve (see picture) terminating in a
Type 1 LP.
Gas Connections
Page | 8
Advertisement
Table of Contents
