Adjusting your monitor image
Using the direct access controls
This section describes the control features to adjust your monitor image.
The direct access controls can be used when the On Screen Display (OSD) is not
displayed.
Table 2-1. Direct access controls
Icon
Control
DDC-CI
1
Exit
Input Source
2
Increase/Up
Brightness
Enable Low Blue Light
3
Disable Low Blue Light
Decrease/Down
Menu
4
Enter
Description
Press and hold for 10 seconds to enable or disable
the DDC-CI function
Exit from menu
Switches the video input source
Shift back to previous level when in OSD mode
Up browsing key
For increasing the value on adjustment bar/tune in
Press to move to next item
Direct access to Brightness adjustment
Press and hold for 3 seconds to enable Low Blue
Light
Press and hold for 3 seconds to disable Low Blue
Light
Down browsing key
For decreasing the value on adjustment bar/tune in
Press to move to previous item
To access OSD menu
Press to confirm selection
Press and hold for 10 seconds will lock menu/un-
lock menu
Press to enter next level on main menu/sub menu
status or enter previous level on adjustment bar
Chapter 2.
2-3