Vivotek ND9322P-v2 User Manual page 20

VIVOTEK - Built with Reliability
Terminal Block Connections
The terminal block pinouts is shown as follows:
The relay pins default status is set to Normally Open. Connect your relay or external devices'
signal wires to the system, the system will automatically detect the current signal status. You
can then trigger the external devices using the DI/DO panel on the live view.
You can also configure the system alarm setting for the system to automatically trigger a relay
pin on the occurrence of system events. See Alarm settings on page 102.
Normally Open
pin
Coil
Common pin
1
2
3
4
5
6
7
8
The GND are common ground for the DIs.
20 - User's Manual
Normally Closed
pin
Relay_NO
Relay_COM
DI1
ssss
DI2
DI3
DI4
GND
GND