Page 1
SWH MS2 10H / SWH MS2 10H series / Models RS2 / RS2 series SWH RS1 30 V SWH RS2 30 H SWH RS1 50 V SWH RS2 50 H SWH RS1 80 V SWH RS2 80 H...
Page 2
Water heater installation Location Water heater mounting methods Water heater mounting Connection to water main Connection to electric mains Ground Fault Circuit Interrupted (GFCI) Water heater control Water heater operation Maintence Troubleshooting Wiring diagram Disposal www.timberk. electrical storage water heater...
17. Do not use the water heater in an explosive or corrosive 7. Magnesium anode is for additional protection of the tank and seam environment. Do not store gas and other volatile flammable liquids next joints. to the appliance it is very dangerous! www.timberk. com electrical storage water heater...
Page 4
Technical characteristics of water heaters are given below in Table 1. Table 1 Product item Description Units SWH RS1 30 V SWH RS1 50 V SWH RS1 80 V SWH RS1 100 V SWH RS2 30 H SWH RS2 50 H...
However, to reduce heat losses in pipelines, the location, where a water heater is to be installed, must be as close to the place, where hot water is used, as possible. Fig. 7 www.timberk. electrical storage water heater...
Page 7
7 discharge pipe 8 composite pressure safety valve * not included in the scope of delivery 9 inlet nozzle ** depending on the product batch, GFCI can be located not within the power cable electric plug www.timberk. com electrical storage water heater...
Page 8
Do not mount additional accessories, such as a shut-off valve, between hooks (for RS1/RS2/RS7 series) (see Fig. 10a). the relief valve and the inlet nozzle. www.timberk. electrical storage water heater...
Page 9
2. Power outlet must be designed for rated current not less than 10A, copper TEST button (2) stranded power cord not less than 3 x 1.5 mm2 in cross section (for copper). Restart button (3) Fig. 11 www.timberk. com electrical storage water heater...
- to reduce the risk of an electric shock, do not disassemble, remove or fill liquid in this appliance. Thermostat handle 7. WATER HEATER CONTROL Control panel for the following models: SWH RS1 30 V SWH RS1 50 V Fig. 13 SWH RS1 80 V SWH RS1 100 V...
Page 11
Maximum temperature inside inner tank is heating in the tank (+58°C (±2°C)) and to the most effective mode of +75°C approx. If you want to reduce the temperature of water, please, electricity consumption. turn the handle anticlockwise. www.timberk. com electrical storage water heater...
» position. The water heater will stop operation. But if you do territory. Cleaning must be performed by special maintenance services. not remove the plug from the receptacle at that, the "Timberk" indicator will You can ask the seller for address of the nearest service center or find it on continue glowing on the control panel notifying you that the appliance is the website www.timberk.com.
POSSIBLE CAUSES TROUBLESHOOTING METHOD energize the water heater, cut off water supply and contact your local Timberk Authorized Service Center for a consult or repair of Heating indicator light 1. Temperature adjustment device is broken. Contact a repairer, TIMBERK service center.
Page 14
Timberk disclaims any liability for possible damage, directly or indirectly caused by Timberk products to people, pets, property in case if it occurred as a result of failure to observe rules and conditions of operation, unit's installation, deliberate or careless actions of the consumer or third parties.
Page 15
ENGLISH ................................................................................................................................................................................. )......................................................« » .......................................................... imberk imberk www.timberk.com...
Page 16
230 /50 . 3D Logic®: DROP Defense SHOCK Defense HOT Defense NON CFC 75 , SUS 304 www.timberk.com...
Page 17
SWH RS1 30 V SWH RS1 50 V SWH RS1 80 V SWH RS1 100 V SWH RS2 30 H SWH RS2 50 H SWH RS2 80 H SWH MS2 10 H SWH RS7 30 V SWH RS7 40 V...
Need help?
Do you have a question about the SWH RS1 30 V and is the answer not in the manual?
Questions and answers