Table of Contents
Advertisement
When your vehicle was shipped from the factory, it was
programmed in Mode 4. The mode to which the vehicle
has been programmed may have been changed since it
left the factory. To determine the mode to which your
vehicle is programmed or to program your vehicle to a
different mode, do the following:
1. Turn the parking lamps on and off.
2. Count the number of chimes you hear. The number
of chimes tells you which mode your vehicle is set
for. (If you do not wish to change the current mode,
you can either exit the programming mode by
following the instructions later in this section or
program the next feature available on your vehicle.)
3. Turn the parking lamps on and off again until you
hear the number of chimes that corresponds to the
mode selection you want.
The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.
Exiting Programming Mode
When programming is complete, turn the ignition to
OFF and reinstall the RADIO fuse.
2-28
New Vehicle "Break
NOTICE:
Your vehicle doesn't need an elaborate
-
"break
in." But it will perform better in the
long run if you follow these guidelines:
D
Keep your speed at 55 mph (88 km/h) or
less for the first 500 miles (805 km).
D
Don't drive at any one speed
--
slow
for the first 500 miles (805 km).
-
Don't make full
throttle starts.
D
Avoid making hard stops for the first
200 miles (322 km) or so. During this time
your new brake linings aren't yet broken
in. Hard stops with new linings can mean
premature wear and earlier replacement.
Follow this breaking
time you get new brake linings.
D
Don't tow a trailer during break
See "Towing a Trailer" in the Index for
more information.
In"
-
--
fast or
-
in guideline every
-
in.
Advertisement
Chapters
Table of Contents
