Pentair CFIGGEN20 User Manual page 24

Water leak
Cell frequently has
mineral buildup
Cell never or rarely
has mineral buildup
COLD Water Led is
on
How to calibrate salinity?
If the user wants to calibrate salinity, please press "MIN" and "MAX" in
the meantime and press quickly three times. The display will show "SALT
Tsys:" By pressing "MAX" to reduce salt level, and "MIN" to increase the
salt level. By pressing "MENU" to return to display for SALINITY.
is dirty or clogged
Insufficient circulation
O-Ring improperly seated
Threaded collars are
cross-threaded
This is due to imbalanced water chemistry and a high Saturation
Index
Water may be corrosive due
to imbalanced water chem.
and a low Saturation Index
Water temperature is too hot or cold for operation
Bad contact line contact of Sensor probe
Damaged Sensor probe
connection, clean
the sensor probe if
necessary.
Ensure operation
of the pump, at
least 25-30 GPM.
Check water level,
filter pressure, or
for air or
blockages in PVC
plumbing.
Ensure O-Rings
are clean and in
good condition.
Inspect threads for
damage, ensure
that each screws
back on without
resistance.
Ensure that your
Saturation Index is
at or near zero, to
avoid damage or
premature cell
failure.
Ensure that your
Saturation Index is
at or near zero, to
avoid damage or
premature cell
failure.
Check operation
of the heater, or
turn off until the
water temp is
between 50° F
TO 122 °F.
Ensure Sensor
probe is well-
connected.
Contact
manufacturer.
22