Table of Contents
Advertisement
FLAT TIRE
-
(LF, LR, RF, RR):
You will hear two
chimes when this message is displayed followed by the
message MAX SPEED 55 MPH (90
km/h).
If this
message appears, do not drive your vehicle above these
limits. The next message to appear is REDUCED
HANDLING. Adjust your driving accordingly. To
acknowledge these warnings, press RESET. After you
press RESET, a message will reappear and you will hear
a chime every 10 minutes until this condition changes.
This message indicates that the pressure in one of your
tires is lower than 5 psi (34 Wa). Next to the FLAT
TIRE message, you can see either LF (left front), LR
(left rear), RF (right front) or RR (right rear) to indicate
to you which tire is flat. You can receive more than one
tire pressure message at a time. To read other messages
that may have been sent at the same time, press RESET.
If a tire pressure message appears on the
DIC, stop as
soon as you can. Have the tire pressures checked and set
to those shown on your Tire Loading Information Label.
See "Extended Mobility Tires" and "Tire Inflation" in
the Index.
When the LOW TIRE PRESSURE or FLAT
TIRE message is displayed on the Driver
Information Center, your vehicle's handling
capabilities will be reduced during severe
maneuvers. If you drive too fast, you could lose
control of your vehicle. You or others could be
injured. Don't drive over 55 mph (90 kmh) when
the LOW TIRE PRESSURE or FLAT TIRE
message is displayed. Drive cautiously, and check
your tire pressures as soon as you can.
Advertisement
Table of Contents
