(9) Removing the Pressure Adjustment Unit
1. Remove the master ejection fan unit.
2. Remove the two screws, and disconnect the
connector.
Then remove the cover.
(S tight hexagon head WH rounded end screw
3 x 6)
3. Disconnect the two connectors. (4 pins, 2 pins)
4. Remove the three screws to remove the
pressure adjustment unit.
(S tight hexagon head WH rounded end screw
4 x 6)
(10) Removing the Press Motor
1. Remove the pressure adjustment unit.
2. Loosen the hexagon socket set screw.
3. Remove the two set screws to remove the
press motor with the motor plate.
(S tight hexagon head WH rounded end screw
3 x 6)
4. Remove the three screws to remove the press
motor.
(Pan head screw with spring washer 3 x 6)
→See (3) above
→See (9) above
Chapter 4
6
Paper Ejection Section
Cover
Holder
Connector
Screw
Pressure
Screw
adjustment unit
Connectors
Screw
Hexagon socket
set screw
Screw
Motor plate
Screw
Screw
Screw
Screw
Screw
Spring
4
Screw
Press motor
217