Table of Contents
Advertisement
EN
Binding
CAUTION: Always keep hands away from the propeller. When armed, the motor will turn the propeller in
response to any throttle movement.
Binding is the process of programming the receiver to recognize the GUID (Globally Unique Identifier) code of a single
specific transmitter.
Binding Procedure
1. Refer to your transmitter's unique instructions for
binding to a receiver.
2. Ensure the transmitter throttle stick is in the lowest
position.
3. Install and connect a fully charged flight battery to the
aircraft.
SAFE® Select Technology
When SAFE Select is activated, bank and pitch limitations keep you from over-controlling the aircraft. Additionally, by
releasing the controls in the event you lose orientation, SAFE Select will keep the aircraft level.
To activate SAFE® Select, flip the Gear channel switch to position 0. Return the Gear switch to position 1 to turn OFF
SAFE Select and fly with just the assistance of AS3X® technology.
If you become disoriented or the aircraft is in a confusing attitude, flip the Gear switch to position 0 and release the sticks.
With the elevator and rudder stick in the neutral position, SAFE Select will automatically keep the airplane in a straight
and level attitude.
Disabling and Enabling SAFE Select
By default, the SAFE Select function of your UMX aircraft is enabled and assigned to the Gear channel switch (channel 5).
If you do not wish to have access to SAFE Select while flying, you can choose to disable SAFE Select functionality. AS3X
will still be active when SAFE Select is disabled.
IMPORTANT: Before attempting to disable or enable SAFE Select, ensure the aileron, elevator, rudder, throttle and gear
channels are all on high rate with the travel set to 100%. Turn throttle hold OFF if it is programmed in the transmitter.
CAUTION: Keep all body parts clear of the propeller and keep the aircraft securely restrained in
case of accidental throttle activation.
1. Power on the transmitter.
2. Power on the aircraft.
3. Hold both transmitter sticks to the inside bottom
corners and toggle the Gear switch 5 times
(1 toggle = full up and down). The control surfaces of
the aircraft will move, indicating SAFE Select has been
enabled or disabled.
Repeat the process again to re-enable or
disable SAFE Select.
DX4e, DX5e, DXe, and DXS Transmitters
The Gear switch is the FMODE switch on the these
transmitters, and the switch needs to be toggled between
position 0 and 2 when disabling/enabling SAFE Select.
6
4. After approximately 5 seconds, the LED on the aircraft
flight control board will begin to flash rapidly.
5. Put your transmitter into bind mode.
6. The LED on the aircraft flight control board will glow
solid when binding is complete.
Mode 1 and 2 transmitters
100%
X 5
100%
UMX Radian
Advertisement
Table of Contents
