Table of Contents
Advertisement
Transmitter Setup
IMPORTANT: The installed receiver has been
programmed for operation specifically in this aircraft.
To operate the various features of this aircraft, follow the
table to setup your computer transmitter.
• The flight mode selection should be assigned to a
2-position switch.
• There are no ailerons on this aircraft. Rudder control is
on the aileron control stick.
• If your transmitter is telemetry capable, the receiver will
communicate the battery voltage and percentage as well
as frame losses and holds. Navigate to the transmitter
telemetry screen to view after binding.
Refer to your transmitter manual for more information
about transmitter setup.
Install the Flight Battery
1. Connect the power lead from the ESC to the battery,
noting correct polarity.
2. Install a fully charged battery in the middle of the
battery tray using double-sided hook and loop
material.
3. Keep the aircraft immobile and away from wind for
five seconds. Once connected to your transmiter, the
LED on the flight controller will illuminate when it is
initialized and ready for flight.
Tip: View the flight controller through the air vent on the
top front of fuselage.
Flight controller LED
LED Color
Red and blue flashing
Solid red and blue
Solid red
Mode
Bind Mode
SAFE
AS3X
Computerized Transmitter Setup
Start all transmitter programming with a blank ACRO
model (perform a model reset), then name the model.
HIGH 100%
Dual Rates
LOW 70%
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
3. Set SWITCH SELECT:
DX7S
GEAR: Gear
DX8
Gear switch operates the flight modes
0 SAFE mode
1 AS3X mode
1. Go to the SYSTEM SETUP
2. Set MODEL TYPE: AIRPLANE
DX6e, DX8e
3. Go to CHANNEL ASSIGN:
DX6, DX7, DX8
Channel Input Config:
(Gen2)
GEAR: Switch A
DX9, DX18,
DX20
Switch A operates the 2 flight modes
iX12, iX20
0 SAFE mode
1 AS3X mode
NX6, NX8,
NX10
EN
Hook and loop tape
5
Advertisement
Table of Contents
