Q'STRAINT QUANTUM Use & Care Manual
Securement system
Hide thumbs
Also See for QUANTUM:
- Installation manual (52 pages) ,
- Installation & user manual (16 pages)
Related Manuals for Q'STRAINT QUANTUM
Summary of Contents for Q'STRAINT QUANTUM
- Page 1 USE & CARE MANUAL THE QUANTUM SECUREMENT SYSTEM MEETS ALL CURRENT REGULATIONS FOR REAR FACING TRANSIT, ® EUROPEAN DIRECTIVES AND ADA/CSA REQUIREMENTS.
-
Page 2: Table Of Contents
WARRANTY Read All Instructions Prior to Installation • This manual is a comprehensive step-by-step instruction guide on how to install the QUANTUM® Securement System and components into vehicles’ floors and walls. • Make sure to read, understand and follow all these instructions. -
Page 3: Important Safeguards And Warnings
• The QUANTUM® Securement System meets all current regulations for rear facing transit, European Directives and ADA/CSA requirements. • The QUANTUM® Securement System is a complete integrated system. Do not alter or modify it in any way and do not interchange or substitute any components. -
Page 4: Compliance
COMPLIANCE • The Wheelchair Securement and Backrest meets the applicable sections of ADA 38.23, CSA QUANTUM ® D-435, FMVSS/CMVSS 572.222, 302 and 209, European Regulations 10 and 107, EC Directive 92/28/EC, and PSVAR 2000. -
Page 5: System Definitions
SYSTEM DEFINITIONS Wheeled Mobility Device 1. QUANTUM® Base 2. Backrest 3. Passenger Securement 4. Stowage Pin 5. Occupant Interface 6. Driver Interface... - Page 6 13-22 AWG) 22 AWG) • 2 Bolts for Mounting Plate • 2 Bolts for Mounting Plate • 1 QUANTUM® Key and • 1 QUANTUM® Key and Manual Manual Release Card Release Card • 1 Installation Manual • 1 Installation Manual •...
- Page 7 SYSTEM DEFINITIONS One Cycle From Stow Position initiate secure sequence by pressing the opperator or user interface. QUANTUM unit will beep twice alerting the operator while the capture is completed. QUANTUM ® ® will beep twice again after completion. To release press operator or user interface.
- Page 8 SYSTEM DEFINITIONS ELECTRICAL AND OPERATIONAL REQUIREMENTS 1. Continuous power source of 15 amps at 12V or 10 amps at 24V. 2. Vehicle Engine must be running (ON), Ignition signal of 12V or 24V (Interlocked). 3. Parking Brake must be engaged (ON), Parking Brake signal of 12V or 24V (Interlocked). 4.
-
Page 9: Quick Installation Sequence
QUICK INSTALLATION REFERENCE This is ONLY a quick guide, for complete installation instructions follow the directions in the “Installation Instructions” section. NOTE: Occupant Securement (8 and 9), if applicable. OCCUPANT INTERFACE OCCUPANT SECUREMENT STOWAGE BACKREST DRIVER NTERFACE QUANTUM FLOOR... -
Page 10: Quantum Effective Layout
QUANTUM EFFECTIVE LAYOUT... - Page 11 QUANTUM EFFECTIVE LAYOUT...
-
Page 12: Operational Sequence
Wall Reset Switch brake engaged. Quantum re- Activate set switch must be set to ON. and Wait Quantum is at Stowed position 30 secs. Boarding Have occupant maneuver in to User must be centered as the securement area and much as possible for ease... -
Page 13: Visual And Audio Sequence
VISUAL AND AUDIO SEQUENCE Driver Driver Master Master Marker Occupant Audible Activity Image Interface, Interface, Switch Switch Light Interface Alarm Secure Light Release Light ON Light OFF Light Stow ON Solid ON Solid ON Solid Position Solid Light Deploy ON Solid Beep Blinking Blinking... -
Page 14: Maintenance And Care
DO NOT LUBRICATE ARMS. 2. Any deficiencies shall be noted below and rectified before the QUANTUM® Securement System is released to the consumer for use. 3. If the repairing technician has any issues not covered by this document or is not clear on what corrective action needs to be taken, they MUST consult the Q’STRAINT®... -
Page 15: Service
From Stow Position to Secure Position back to Stow Position. WARNING: Once the QUANTUM® reaches 9,500 cycles, every time the vehicle is turned “ON” 2 Alert Beeps will be heard for 1 minute indicating that the QUANTUM® needs to be serviced soon. The QUANTUM® will still be operational. Make sure to con- tact your authorized Q’STRAINT®... -
Page 16: Warranty
3 YEAR WARRANTY - ALL SYSTEMS, PRODUCTS & ACCESSORIES WARRANTY REGISTRATION In order to take full advantage of Q’STRAINT’S warranty, register your product online at: www.qstraint.com/registration PLEASE DO NOT MAIL IN THIS REGISTRATION. Before going online, have your vehicle’s registration handy as well as the equipment’s: Serial # _________________________ Part # __________________________ Q’STRAINT’S LIMITED WARRANTY: Q’STRAINT®... - Page 18 This manual was printed on 30% post-consumer stock using vegetable oil based inks and is 100% recyclable. © 2017 Q’STRAINT®. All Rights Reserved. QUANTUM® is a registered trademark of Q’STRAINT®, Inc. Our products are protected under the following patents: www.qstraint.com/patents FOR TECHNICAL SUPPORT OR TO FIND YOUR NEAREST AUTHORIZED DEALER: Q’Straint Europe...
Need help?
Do you have a question about the QUANTUM and is the answer not in the manual?
Questions and answers