Sony PCV-RX891 Online Help Center (VAIO User Guide) User Manual page 59

7.
Slide the new drive into the drive holder and align the holes on each side of the drive bay.
Attaching the driv e screws
8. Secure the drive to the drive holder with screws, through the holes on each side of the drive holder.
Your new hard disk drive is supplied with the necessary screws. Do not overtighten these screws when securing
the drive to the drive holder.
9.
Align the drive holder with the tracks on the inside of the chassis. Slide the drive holder in completely.
10. Push down on the drive holder tab to lock it into position.
11. Connect the second drive connector to the new drive. Orient the connector to align pin 1 on the red side of the
ribbon cable with pin 1 on the new drive.
12. Connect the second power connector to the new drive. See the instructions supplied with your drive.
Replacing the driv e holder
(PCV- RZ series m odel equipped with Giga Pocket)
Page 59