Setting The Rinse Aid Amount; Switch Off Rinse System - Bosch SGV4HAX48E User Manual

NL Rinse System
Top up the rinse aid up to the max
2.
mark.
If rinse aid has spilled over, it must
3.
be removed from the rinse aid
container.
Rinse aid spilled over can cause
excessive foaming during the wash
cycle.
Close the lid of the rinse aid
4.
reservoir.
a The lid audibly clicks into place.
Set rinse aid amount
If streaks or water spots remain on
the dishes, adjust the amount of rinse
aid.
on to press.
1.
Approx. 3 seconds on
2.
to access the basic settings.
a The display shows Hxx.
a The display shows
to give.
Just as often on
3.
until the display shows the
factory-set value r05.
Press as many times until
4.
the desired amount of rinse aid
has been set.
26
max
5.
Switch off the rinse system
If the rinse aid refill indicator bothers
you, e.g. if you use a combined
dishwasher detergent with a rinse aid
component, you can switch off the
rinse aid system.
Tip: The function of the rinse aid is
limited in combined detergents. You
usually get better results by using
rinse aid.
1.
2.
Busy-
a The display shows Hxx.
a The display shows
reflected
3.
to press
4.
5.
a The rinse aid system is
– A low setting adds less rinse aid
during the wash cycle, reducing
the streaks on the dishes.
– A higher setting adds more rinse
aid during the wash cycle,
reducing water spots and
improving drying results.
To save the settings, press for
approx. 3 seconds.
on to press.
Approx. 3 seconds on
to access the basic settings.
to give.
Press just as often
until the display shows the
factory-set value r05.
Press as many times until
the display shows r00.
To save the settings, press for
approx. 3 seconds.
switched on and the rinse aid
refill indicator is deactivated.
Busy-