Switching Off Water Softening - Bosch SGV4HAX48E User Manual

NL Softening System
salt immediately before the program
start. The required amount of
softening salt depends on the water
hardness. The higher the water
hardness, the greater the amount of
softening salt required.
PAY ATTENTION!
s
Dishwasher detergent can damage
the water softener.
The reservoir of the softener
▶
Only fill the water supply with
special salt for dishwashers.
s
The rinse aid container can be
corroded by dishwasher softening
salt.
To ensure that
▶
spills out of the softening salt
from the rinse aid container, the
softening salt must be filled into
the water softening salt
reservoir immediately before the
program starts.
Open the lid of the softening salt
1.
reservoir and remove it.
When using for the first time: fill
2.
the reservoir completely with water.
Depending on the device version
1
24
3. Note: Only use special salt for
dishwashers.
Do not use salt tablets. Do not
use table salt.
Place the softening salt in the
softening salt reservoir.
Funnel
1
Fill the water softening salt
reservoir completely with softening
salt. The water in the reservoir is
displaced and flows away.
Fit and close the lid of the
4.
reservoir.
Switch off water softening
If the refilling salt display bothers you,
for example if you use a combined
dishwasher detergent with a salt
component, you can switch off the
display.
Remark
To avoid damage to the appliance,
only switch off the water softening
in the following cases:
s The water hardness is maximum
times 21 °dH and you use a
combined dishwasher detergent
with salt substitutes. You can use
combination detergents with salt
substitutes
a