Advertisement
Setup Instructions
Connect the mouse and receiver when you use the mouse for the first time and when
replacing batteries.
1. Remove the battery compartment cover and install two AAA alkaline batteries as
indicated by the polarity symbols (+/-), then replace the cover.
2. Turn on the mouse.
3. Plug the receiver into an available USB port.
4. Press the USB receiver's Connect button.
5. Press the mouse's Connect button.
Note:
• The unit will go into stand-by mode after a few seconds of idling. Slide the mouse
around to wake it up.
• The unit will go into sleep mode after 6–8 minutes of idling and the LED will go off.
Click the mouse button to wake it up.
Quick Installation Guide
Advertisement
