Table of Contents
Advertisement
FZDA07ELEF2/EREF2/MRHF2
• When ACC turns on (OFF → ON) at 1 hour 59
minutes, keep counting from that timing (1 hour 59
minutes)
• When ACC is reset at 1 hour 59 minutes, keep
counting from 1 hour 00 minute.
7
Number of disc ejection (AUDIO)
∗ The display shall be updated every time when there
is any change in the data.
• Count from 0 to 60000 times.
• Record the number by the count in E2PROM.
8
Number of disc ejection (MAP)
∗ The display shall be updated every time when a
screen is shifted to other screen.
At Audio side;
• Count from 0 to 60000 times.
• Record the number by the count in E2PROM.
9
Number of panel mechanism operations (open and
close)
∗ The display shall be updated every time when a
screen is shifted to other screen.
At Audio side;
• Count from 0 to 60000 times.
• Record the number by the count in E2PROM.
• When the panel is fully opened, it is counted as one
time (one count).
A
Return to "Audio Diag Menu" screen.
B
AMP Power ON Time clear key
E
DC offset detection/Number of DC offset detection
clear key
F
Disc operation time (AUDIO) clear key
H
Number of disc ejection (AUDIO) clear key
J
Number of panel mechanism operations clear key
■ Vehicle Signal Info. screen
• Display CAN connection status.
• Display connection status in vehicle signal.
• Display connection status of the GPS Antenna.
∗1 When the equipment is connected it is shown in blue and
when not connected it is shown in red.
This display shall indicate the status.
∗2 Unlike the Maker Line Diag, the ON/OFF condition of
the vehicle speed shall be such that the vehicle speed is
turned ON when the vehicle speed reaches the forced
running by the navigation.
36
TEST MODE
1
Vehicle Signal Info.
2
NAVI Unit
• GPS Antenna
3
4
CAN Signal
5
• CAN
6
• BCU
• Meter
7
• Air-Con
8
● Description of operations
1
Title
2
3
Display connection status of the GPS Antenna.
4
5
Display CAN Unit line information.
6
Display Body Control Unit status.
7
Display Meter Unit status.
8
Display Air-Con status.
9
10 Display illumination status in vehicle signal.
11 Display vehicle speed information in vehicle signal.
12 Display reverse status in vehicle signal.
13 Display ignition status in vehicle signal.
14 Display parking status in vehicle signal.
A
Return to "Engineering Diag Menu (Page3)" screen.
■ Touch Panel Adjust screen
∗ The correction mark shall be designed such that the center
point can be identifi ed clearly (such as +, X, etc).
Modifi ed for 4-point touch correction.
C
A
● Description of operations
1
Title
Touch correction shall be made in the following order
of the sequence: "Lower left correction → Upper light
correction → Upper left correction → Lower right
correction"
E
Shift to "Engineering Diag Menu (Page3)" screen.
(Touch correction reset)
Vehicle Signal
Connect
• Illumination
• Speed
• Reverse
• IGN
OK
• Parking
OK
OK
NG
1
Touch Panel Adjust
RESET
Menu
E
F
A
Menu
9
OFF
10
OFF
11
ON
12
OFF
13
ON
14
B
D
Hide quick links:
Advertisement
Table of Contents
