Repeat Last Command; Product Information - Digicom Donatello User Manual

Donatello
A/

Repeat last command

Cause Donatello to repeat the last AT command. This command is neither preceded by AT nor
followed by CR.
Store: n/a
A Answer incoming data call
Cause Donatello to go off hook and attempt a handshake in answer mode
Store: n/a
D Dial
Instruct to go off-hook and execute the phone number.
D 0-9 Dial the dial string.
DS=0-19 Dial the dial string associated to the memory location (from 0 to 19) stored using &Z command
Dn1*n2 Dial two number (n1 and n2) for MLPPP at 128Kbps. If the service access at 128Kbps is over a
single telephone number the n1 is egual to n2.
Example: ATD702611*702611
See also the command A%A2 for MLPPP activation
Store: n/a
E Echo commands ON/OFF
Enable or disable echo of commands from the Computer to Donatello.
E0 Command echo disabled
E1 Command echo enabled
Store: S14 (bit 1)
H Hang up
Hang up the Donatello from the ISDN network.
H0 Hang up Donatello from the ISDN network (off-line). This command is accepted only in Escape
mode.
Store: n/a
I

Product Information

I0 Model.
I1 Checksum calculation, the result is displayed in Hexadecimal digit.
I2 Compare the checksum calculation with the stored value, the response will be OK or ERROR.
I3 Revision level.
I4 Display Central office
Store:= n/a
N Select the speed adaptation (V.110 or V120)
N0 In Originate mode:Donatello makes the connection at the speed fixed from register S37
In Answer mode:Donatello accepts incoming call in accordance with the set-up of the command
AT%A2 and the register S37.
3.6
Description
Default= n/a
Default= n/a
Default= n/a
Default= E1
Default= n/a
Default= n/a