Ricoh MT-C4 Manual page 62

Paper Size Detection - Trays 2 & 3
Tray 1 does not have a
size sensor.
Input the paper size with
SP5019 002.
Trays 2 and 3: If the user
wants to use a paper size
that cannot be detected by
the sensors, they can
select the paper size with
the Tray Paper Settings
button on the operation
panel.
The 'custom size' button
only appears if SP 5112
is enabled
Slide 62
Paper Size Detection is changed to a system that is similar to Bellini-C3.
Tray 1 does not have a size sensor or a dial.
The paper size for tray 1 has to be stored with SP5019 002.
Adjustable side fences also need to be moved. This can only be done
by a technician. tray does not have paper size switches. Every time the
paper size is changed by moving the front and back fences, you must
enter the selected paper size with SP5019-002.
If the A3/DLT kit is installed in Tray 1, and SP5019 002 is set to
'Custom size', then a custom size for tray 1 can be input with SP 5040
(vertical dimension) and 5041 (horizontal dimension). A custom size
cannot be set if Tray 1 is a tandem tray.
For trays 2 and 3, the actuator at the rear of the tray turns on the paper size
switches. The machine detects the size by the combination of switches that
are turned on. The output from the switch depends on the position of the dial.
The machine can only detect a certain number of set paper sizes. Other
sizes cannot be detected. The user must use the Tray Paper Settings button
on the operation panel.
There is no * setting, because there is no dial.
The default setting is 'Auto Paper Detect', which means that the
machine takes the paper size from the sensor. To use a paper size that
is not in the table, use the Tray Paper Settings button.
If the fence position is incorrect (in the case of Auto Paper Detect) or if
the size is not the same as set with the operation panel, jams will occur.
Note SP 5112 however: The machine default is 'disabled' which means
the user cannot use non-standard paper sizes.
There is no SP for the F sizes (8 x 13, 8.5 x 13, 8.25 x 13), because the
cassette can detect these three sizes automatically.
Also note that the tray can detect 12 x 18" automatically.
62
MT-C4 Training