Table of Contents
Advertisement
ADJUSTING DISTANCE (CONTINUED)
(3) Acceleration when there are no longer any preceding vehicles driving
slower than the set speed
The system accelerates until the set speed is reached. The system then
returns to constant speed cruising.
Note: When your vehicle is too close to a vehicle ahead, and sufficient automatic
deceleration via the cruise control is not possible, the display will flash and the
buzzer will sound to alert the driver. An example of this would be if another driver
cuts in front of you while you are following a vehicle. Depress the brake pedal to
ensure an appropriate vehicle-to-vehicle distance.
SWITCHING TO CONSTANT SPEED (CRUISE) CONTROL MODE
If you are already using DRCC "
first, then push and hold ON-OFF button for at least 1.5 seconds to switch.
Note: When the engine is turned off, it will automatically default to DRCC.
SETTING CONSTANT SPEED (CRUISE) CONTROL
To adjust speed or cancel, see steps (2) and (3) of ADJUSTING SET SPEED on
page 37.
Refer to the Toyota Owner's Manual for additional information on DRCC operation,
settings adjustments, limitations, and precautions before attempting to use it.
1.5 seconds
," push ON-OFF button to turn the system off
Set
39
Advertisement
Table of Contents
