Combustion Chamber; Heating Element - SUNWIND El-dorado 720100 User Manual

English

Combustion chamber

The chamber must be emptied at least once a week, even if it is not full, because the ashes
will petrify over time after repeated combustions, making it difficult to empty the ashes.
Should the bottom of the pot become filled with petrified ashes, the easiest solution would be
to soak this part of the pot in approximately 10 mm boiling water and subsequently initiate a
combustion. The boiling water will loosen up the remaining ashes so that the pot can be com-
pletely emptied again.

Heating element

The heating element has a durability of 2-5 years, depending on the frequency of which it is
used. The element is changed during the periodic service at least every 5 years. Frequent use
may shorten the lifetime of this element, which is considered a wear part. We would recom-
mend replacing the element every other year if used frequently, to avoid that it stops working
during use.
Adjustment of combustion time and temperature
The toilet is designed to consume a minimum amount of energy. The combustion time and
temperature in the chamber has been optimised for the average need of a family of 4 people.
Frequent visits and large amounts of waste may result in incomplete combustion of some of
the paper - or, less frequently, the excrements. Should this occur, the combustion time may be
adjusted. We would recommend increasing the time by a maximum of 5 minutes at a time be-
fore testing the combustion again. The ideal temperature for combustion is between 540°C and
560°C. Do not adjust the thermostat beyond this range! To adjust the temperature, the thermo-
stat must be activated by running a combustion. Then press "Mode" and adjust the tempera-
ture up or down by pressing the arrows up and down.
Motor relay Combustion time Thermostat
31