Electrical Connection - Miele HG07 Operating Instructions Manual

Electrical connection

The dishwasher is "connector-ready" as
standard for connection to an earthed
socket.
The socket must be easily accessible
after the dishwasher has been installed.
If that is not possible, ensure that a
suitable means of disconnection is
provided on the installation side for
each pole.

Risk of fire from overheating.
Connecting the dishwasher to a
multi-socket adapter or to an exten-
sion lead can overload the mains
connection cable.
For safety reasons, do not use an ex-
tension lead or multi-socket adapter.
The electrical installation must comply
with VDE 0100 requirements.
For safety reasons, we recommend us-
ing a type  residual current device
(RCD) in the assigned electrical installa-
tion for connecting the dishwasher.
If the mains connection cable is dam-
aged, it must only be replaced with a
specific mains connection cable of the
same type (available from the Miele
Customer Service Department). For
safety reasons, such replacement may
only be carried out by a qualified spe-
cialist or the Miele Customer Service
Department.
These operating instructions and the
data plate indicate the nominal power
consumption and the appropriate fuse
rating. Compare this information with
the data of the on-site electrical con-
nection.
If in any doubt, consult a qualified elec-
trician.
Do not connect the dishwasher to a
stand-alone inverter such as those used
with an autonomous power supply, e.g.
solar power. When the dishwasher is
switched on, power surges could result
in a safety switch-off. This could dam-
age the electronic module.
Installation
91