Cleaning The Control Panel; Cleaning The Reflector Panel; Cleaning The Appliance Front - Miele HG07 Operating Instructions Manual

Cleaning the control panel

 The control panel should only be
wiped with a damp cloth.

Cleaning the reflector panel

The reflector panel for the optical in-op-
eration indicator light is situated on the
protective foil underneath the worktop.
 The reflector panel should only be
cleaned with a damp cloth if neces-
sary.

Cleaning the appliance front


Damage due to soiling.
Soiling that is left too long might be-
come impossible to remove and
could cause the external surfaces to
alter or discolour.
It is therefore best to remove any
soiling immediately.
 Clean the appliance front with a clean
soft sponge and a solution of warm
water and washing-up liquid. After
cleaning, wipe the surfaces dry using
a soft cloth.
A clean, damp microfibre cloth
without detergent can also be used.
Cleaning and care
To avoid damaging the external sur-
faces, do not use the following:
- Detergents containing soda, ammo-
nia, acids or chlorides
- Detergents containing descaling
agents
- Abrasive detergents, e.g. scouring
powder, scouring liquid, or pumice
stones
- Detergents containing solvents
- Stainless steel cleaning agents
- Dishwasher cleaner
- Oven cleaner
- Glass cleaning agents
- Hard, abrasive brushes or sponges,
e.g. pot scourers, brushes or
sponges that have been previously
used with abrasive cleaning agents
- Eraser stain remover blocks
- Sharp metal scrapers
- Wire wool
- Steam cleaners
63