Headlamp High/Low-Beam Changer; Flash-To-Pass; Windshield Wipers - Cadillac 2005 DeVille Owner's Manual

Headlamp High/Low-Beam Changer

Push forward to change the headlamps from low
beam to high. Pull the lever back and then release it to
change from high beam to low.

Flash-to-Pass

This feature lets you use the high-beam headlamps to
signal the driver in front of you that you want to pass.
Pull and hold the turn signal lever toward you to
use. When you do, the following will occur:
•
If the headlamps are either off or in the Daytime
Running Lamps (DRL) mode, the high-beam
headlamps will turn on. They will stay on as long as
you hold the lever there. Release the lever to turn
them off.
•
If the headlamps are on high beam, they will switch
to low beam. To return to high beam, push the lever
away from you.
This light on the instrument
panel cluster will be on,
indicating high-beam
usage.

Windshield Wipers

To operate the windshield wipers turn the band, located
on the multifunction lever, upward or downward.
WIPER N : Turn the band on the turn signal lever to
control the wipers.
MIST: Turn the band toward you to MIST and then
release it for a single wiping cycle. For more cycles, hold
the band on MIST longer.
LO or HI (Low or High): Turn the band away from you
to either LO (low speed) or to HI (high speed),
depending on the wiper speed you want.
Delay: Turn the band to one of the delay positions to
set the wiper speed for a long or a short delay between
wipes. The closer you move it to LO, the shorter
the delay.
3-9