Gate Operator And Canadian Programming; Using Homelink - Cadillac 2005 DeVille Owner's Manual

Gate Operator and Canadian
Programming
Canadian radio-frequency laws require transmitter
signals to "time out" or quit after several seconds of
transmission. This may not be long enough for
®
HomeLink to pick up the signal during programming.
Similarly, some U.S. gate operators are manufactured
to "time out" in the same manner.
If you live in Canada, or you are having difficulty
programming a gate operator by using the
"Programming HomeLink
where you live), replace Step 3 under "Programming
®
HomeLink " with the following:
Continue to press and hold the HomeLink
you press and release every two seconds (cycle)
your hand-held transmitter until the frequency signal has
been successfully accepted by HomeLink
indicator light will flash slowly at first and then rapidly.
Proceed with Step 4 under "Programming HomeLink
to complete.
®
" procedures (regardless of
®
button while
®
. The

Using HomeLink

Press and hold the appropriate HomeLink
least half of a second. The indicator light will come
on while the signal is being transmitted.
Erasing HomeLink
To erase programming from the three buttons do the
following:
1. Press and hold down the two outside buttons until
the indicator light begins to flash, after 20 seconds.
Do not hold the two outside buttons for longer
than 30 seconds.
2. Release both buttons.
®
HomeLink is now in the train (learning) mode and can
be programmed at any time beginning with Step 2
under "Programming HomeLink
this section.
Individual buttons cannot be erased, but they can
®
"
be reprogrammed. See "Reprogramming a Single
®
HomeLink Button" following this section.
®
®
button for at
®
Buttons
®
" shown earlier in
2-47