Programming The Homelink - Cadillac 2005 CTS Owner's Manual

Programming the HomeLink

Transmitter
Do not use the HomeLink
door opener that does not have the "stop and reverse"
feature. This includes any garage door opener model
manufactured before April 1, 1982. If you have a newer
garage door opener with rolling codes, please be
sure to follow steps 6 through 8 to complete the
programming of your HomeLink
Read the instructions completely before attempting to
®
program the HomeLink
the steps involved, it may be helpful to have another
person available to assist you in programming the
transmitter.
Keep the original transmitter for use in other vehicles
as well as for future HomeLink
also recommended that upon the sale of the vehicle,
the programmed HomeLink
for security purposes. Refer to "Erasing HomeLink
Buttons" or, for assistance, contact HomeLink
on the internet at: www.homelink.com or by
calling 1-800-355-3515.
2-48
®
®
Transmitter with any garage
®
Transmitter.
Transmitter. Because of
®
programming. It is
®
buttons should be erased
®
Be sure that people and objects are clear of the
garage door or gate operator you are programming.
When programming a garage door, it is advised to
park outside of the garage.
It is recommended that a new battery be installed
in your hand-held transmitter for quicker and more
accurate transmission of the radio frequency.
Programming HomeLink
Your vehicle's engine should be turned off while
programming the transmitter. Follow these steps to
program up to three channels:
1. Press and hold down the two outside buttons,
releasing only when the indicator light begins to
flash, after 20 seconds. Do not hold down the
buttons for longer than 30 seconds and do not
repeat this step to program a second and/or third
transmitter to the remaining two HomeLink
2. Position the end of your hand-held transmitter about
®
1 to 3 inches (3 to 8 cm) away from the HomeLink
buttons while keeping the indicator light in view.
3. Simultaneously press and hold both the desired
button on HomeLink
button. Do not release the buttons until Step 4
has been completed.
®
®
®
and the hand-held transmitter
buttons.
®