Cleaning And Maintenance - PURE It Pureit Copper+ Mineral RO+UV+MF Instruction Manual

INSTALLING YOUR PUREIT
COPPER + ECO MINERAL RO+UV+MF
1. The puri er should be installed by a trained Pureit technician
2. It can be wall-mounted or used as a table top puri er
3. The puri er should be placed in area which is free of ants/insects/other pests.
4. The puri er should be placed close to the plumbed inlet connection
(not more than 2 metres).
5. Do not install the puri er above any electric socket
6. Avoid sharp bends to the pipes of the product
7. Do not use an extension cord
8. Make sure you test the input water TDS (Total dissolved salts) before installing the
puri er. The maximum input TDS should not exceed 2000 PPM.
TAKING CARE OF PUREIT
COPPER + ECO MINERAL RO+UV+MF
1. Use only the plug provided with the puri er
2. The puri er should not be connected to any hot water tap. Do not run hot water over
45°C through the puri er
3. Make sure that the power is kept on to dispense the water. Press the Touch button to
dispense water from the storage tank.
4. Water from waste water tube is not suitable for drinking. You can use that water for
gardening or cleaning oors.
5. Store water only in the puri er and don't use bottles and containers. If you do so,
water may get contaminated.
RECOMMENDATIONS/CAUTIONS:
1. Discard rst glass of RO water when dispensed immediately after dispensing Copper
RO water, to avoid any traces of Copper in RO water.
2. Doctor's advice is recommended for Consumption of more than 30% RDA equivalent
Copper RO water in adults.
3. Elders kindly moderate consumption of Copper RO water for children.
4. Stop using the Copper RO water if you feel any change in taste / discomfort & call
Pureit call centre to inspect the device.
5. Consult your doctor, if you are sensitive to copper water.

CLEANING AND MAINTENANCE

Water Dispensing
Point
1. Do not use detergents, soap or wet cloth to clean the external parts. Use dry and soft
cloth to clean the front cover. It is recommended to use a 3M mop cloth for cleaning.
2. Clean the dispenser by using disinfectants like bleach/hypochlorite (50 PPM available
chlorine). Discard 2 litres of water after cleaning the dispenser.
3. Discard water from detachable tray & maintain in dry condition.
Storage Tank
1. Discard the water in the storage tank once in 15 days.
2. Drain the water in the storage tank if puri er is not used for 2 days.
3. Clean the storage tank once a month with disinfectant solution. To purchase this
solution, call us at 1860-210-1000 now.
4. How to clean the tank: Open the cleaning solution dispenser and put 1 ml of the
disinfectant solution (10–15 drops) into the storage tank. (Ensure the tank is full).
Drain the entire tank after 10 minutes.
5. No foreign material (like dust/ants/insects/other pests) should enter the storage tank.
The ltered water in the storage tank may deteriorate in the process.
6. The point-of-use reverse osmosis drinking water treatment systems addressed by NSF-58
standard are designed to be used for the reduction of speci c substances that may be
present in drinking water supplies (public or private) which are considered to be
microbiologically safe and are of known quality.
7. The output water may continue to have ora which are harmless and pose no health
hazard to normal healthy adults and children.
Disposal Guidelines (Electrical): To prevent possible harm to the environment or human health from uncontrolled waste
disposal, please separate electrical items in this product such as power supply adaptor, control circuits, LED panel, and
wiring from other types of waste and recycle them responsibly to promote sustainable use of material resources.
Contact either the retailer where you purchased this product, or local government o ce for details of where and
how these items can be taken for environmentally safe recycling.
3