PURE It Classic UV+ G2 Instruction Manual

UNDERSTANDING THE DIGITAL DISPLAY SYSTEM
Power Switch and GKK Life Ring
Power ON/OFF
Advance Alert System ™ (AAS) – A red ring will start blinking around the Power ON
button to alert you 15 days* before end of life Germkill Kit™
™ (ASO) – At the end of 15 days* the ring around the Power ON button
will become solid red and the device will stop dispensing water
Water Dispense Switch and UV Ready / Fault Ring
Dispense Water – When you press the Dispense button, a blue ring starts to appear
around the button which will complete a full circle in 40 seconds. The device will
water.
Fault Indicator – The blue ring around the water drop might blink in case of any
fault with the device
We strongly recommend to Power O the device, when not in use, otherwise you may get warm water.
* Based on water consumption of 10 litres/day.

FAQs

How does Classic UV+ G2 purify water?
Classic UV+ G2 has a 4-stage puri cation system which ensures you get water that is
'As safe as boiled water™' that meets the stringent standards set by the USEPA for
Microbiologically safe drinking water. First, the water passes through the Sediment Filter
which removes ne and coarse particulate impurities/dirt.The second stage is the
Activated Carbon Filter™ that removes remaining dirt, chlorine and organic impurities like
harmful pesticides. It also absorbs colour and odour causing organic compounds from
water. Then the water passes through Mesh Filter, which ensures that no suspended / dirt
particles enter the UV chamber. High intensity UV rays ensure maximum UV intensity for
inactivation of bacteria, virus and parasites to deliver safe water always.
What is Advance Alert System™?
Classic UV+ G2's Advance Alert System™ warns you 15 days* in advance before your
consumable expires, so that you can get it replaced before the GKK life expires and puri er
stops working. Please refer to the LED indicator panel instructions for details.
Does this mean that I need to change the UV lamp after every 6000* litres?
No. The UV lamp is designed to last typically for 10,000 working hours. You need to change
only the GKK after typically 6000* litres of water has been puri ed.
Can I change the GKK?
It is not recommended for the users to change the GKK by themselves. Please call Pureit
Helpline when you need to replace the GKK.
Reach Pureit @
1860-210-1000
www.pureitwater.com

TECHNICAL SPECIFICATIONS

Pureit Classic UV+ G2 Puri er
Gross dim: Height x Width x Depth 425 mm x 444 mm x 218 mm
Net dim: Height x Width x Depth 360 mm x 225 mm x 200 mm
Gross weight (Dry) 4.2 Kg
Pressure range 5 psi to 30 psi
1 ltr. to 2 ltr. / min.
Sediment Filter, Activated Carbon Filter
High Intensity UV Chamber.
Material used for construction Food safe, non-toxic, engineering plastics
Turbidity – 1 NTU (max.)
Input Water Quality
Total Dissolved Solid – 200 mg/litre (max.)
Rated Voltage 165~240V a.c.
Power Rating 26W
Germkill Kit
™
Material used for construction Food safe, non-toxic, engineering plastics
This has been designed to give typically 6000* litres
of water under tested conditions of 20 psi input
pressure and 25 °C temperature and less than 1 NTU
(Input water quality)
Expiry period Three years from packaging
Meets stringent criteria of Environmental Protection
Agency, EPA (USA) for harmful virus and bacteria
Germkill performance standard
removal
Sediment Filter – 1EA, Activated Carbon Filter – 1EA,
Gaskets – 4EA, Cleaning Solution – 1EA and Muslin
Net Contents
Cloth -1EA
*All technical speci cations related to puri cation capacity/life/ ow rate are the results under standard test conditions,
which will vary depending upon di erent usage conditions like, input water quality, pressure and temperature.
Can I drink the rst puri cation cycle of water from the puri er?
No, it is recommended to throw the rst 5~10 litres of water when the new Classic UV+ G2
puri er is installed, and also whenever the GKK is replaced. It will only take 3-5 minutes.
Can I open and service my puri er?
It is not recommended to open and service puri er by an individual. Call Pureit helpline if
you face any issue which requires servicing and opening of the puri er.
What should I do if any part of the puri er is broken?
Please call the Pureit helpline number. Our technicians will visit your house and guide you
on the repairs required. There will be a nominal visiting charge and you would need to buy
the parts required.
What should I do if water pressure at my home is less than 5 psi?
Technicians will suggest you to purchase a booster pump, so that pressure of input water
will be appropriate for functioning of the puri er.
What should I do if water pressure at my home is more than 30 psi?
Technicians will suggest you to purchase a pressure regulating value, so that water pressure
inside device will be regulated according to safety rating of.
*All technical speci cations related to puri cation capacity/life/ ow rate are the results under standard test conditions, which will vary depending
upon di erent usage conditions like, input water quality, pressure and temperature.
, Mesh Filter,
™
5
Welcome to the Pureit family
World's Largest Water Puri er Selling Company
INSTRUCTION MANUAL
6
*