Product Description And Intended Use; Safety Instructions - FIAM. SAHARA 4120 Product Information

SAHARA Table
EN
Art. 4120 - 4121 - 4122 - 4123 - 4124 - 4125 - 4126 - 4127
Read this information carefully before using the product and keep it for
future reference. Failure to comply carefully with the instructions which
follow may put the safety of the product and its users at risk.

Product description and intended use

1
• Product description and composition
The SAHARA Table - Art. Code 4120 - 4121 - 4122 - 4123 - 4124 - 4125 - 4126 - 4127 is a Table intended as an item of
indoor furniture. It is manufactured from curved float plate glass. The SAHARA Table was produced at the FIAM ITALIA SPA factory
at Via Ancona 1/B, 61010 Tavullia (PU), Italy - Tel: +39.0721.20051 - Fax: +39.0721.202432 - www.fiamitalia.it
• Intended use
The article known as SAHARA is designed and built to serve as a Table for indoor use and must therefore be used only for this
purpose and no other.
For more information about the product's intended use please refer to section "2) SAFETY INSTRUCTIONS".

Safety instructions

2
To ensure that our product is used in the conditions of the utmost safety, we urge you to comply with the safety instructions
provided below. If in doubt or if you require further information concerning the use of the product, please contact us on the
telephone numbers stated in this document.
• Transporting and storing the SAHARA Table in the original packaging
The SAHARA Table, in its original packaging (2 packs; one for the frame and one for the top), must be transported taking the
greatest care to prevent knocks and shaking. It must be stored indoors in a dry place.
Place the SAHARA Table in the original packaging, in the horizontal position. The arrows on the label on the packaging must be
vertical and pointing upward.
Never place weights or loads in excess of 200 Kg on the original packaging, since exceeding this weight may cause the breakage
of the article.
The SAHARA Table in the original packaging weighs about 153 kg.
It must therefore be placed on surfaces capable of supporting its weight.
• Removing the packaging - assembly
To remove the original packaging of the SAHARA Table, proceed as follows.
a) Place the packaging crate horizontal. The arrows on the labels on the outside must be vertical and pointing upward.
b) Open the packaging crate and remove the sheets of polystyrene. Do not use hammers, saws, cutters or other tools which may
damage the SAHARA Table.
c) Remove the frame of the SAHARA Table from its packaging. At least two people are required for this operation. Wear gloves
which assure a good grip on the float glass.
d) Remove the top of the SAHARA Table from its packaging and place it on the frame. At least two people are required for this
operation. Wear gloves which assure a good grip on the float glass.