HP t610 Series Hardware Reference Manual page 25

WARNING! You must remove the left side panel to access the system board. Before removing the
side access panel, ensure that the thin client is turned off and the power cord is disconnected from the
electrical outlet.
CAUTION: Static electricity can damage the electronic components of the computer or optional
cards. Before beginning these procedures, ensure that you are discharged of static electricity by briefly
touching a grounded metal object. When handling a memory module, be careful not to touch any of
the contacts. Doing so may damage the module.
To install the flash memory module:
1. If an internal hard drive is installed, remove it. See
for instructions.
2. Locate the correct flash memory module socket on the system board.
a. The PATA socket (1) is populated by default.
b. The SATA socket (2) can be populated with an optional SATA flash memory module.
Figure 2-12 Identifying the Flash Memory Module sockets
Removing an internal hard drive on page 21
Installing thin client options
19