Table of Contents
Advertisement
7. OPTIONAL TYPE 801 CUTTING BLADE can be used when cutting a lot ½" or smaller width bar.
Your cutting times will be faster because the cutter takes less time to advance and makes contact
with the bar sooner. REPLACE the regular "stationary" cutting blade with the Optional Type 801
cutting blade. NOTE: This blade must NEVER be installed in the "moving" blade position. As
always, make certain the securing bolts are tight. Adjust the bar support to keep bar at a 90
degree angle to the cutting blades. In order to cut bar over ½" in diameter, the Optional Type 801
blade must be removed from the "stationary" socket and replaced with a standard size cutting
blade.
NEVER place hands or fingers near cutter while in operation or SERIOUS INJURY
COULD RESULT.
______________________________________________________________________
1. GREASE fitting on top of the shaft that holds the adjustable bending support roller.
2. GREASE fitting on the left side of the cutter head. (units with optional cutter)
3. TIGHTEN blade securing bolts before each use period. Turn on the machine and make sure
Cut/Bend lever is in the CUT position. Press the foot pedal and when the ram has extended about
¾ of the way out, flip off the on/off switch and turn the motor off. The ram will stay in the extended
position until the machine is turned back on again. Use the allen wrench provided on the machine
to tighten the two bolts for each blade. DO NOT cut with loose cutting blades or severe damage
to the cutter and broken blades will result.
SERIOUS INJURY to operator could result from a broken blade. ALWAYS WEAR
EYE PROTECTION WHEN USING MACHINE.
DAILY MAINTENANCE
Advertisement
Table of Contents
