Table of Contents
Advertisement
DO NOT attempt to operate this machine until you have read thoroughly and
understand completely all instructions, cautions, dangers, and warnings, contained
in this manual.
ALWAYS WEAR SAFETY GLASSES when operating machine, or when working
close to the machine when it is being operated by others.
ALWAYS KEEP FINGERS AWAY from cutting blades and bending rollers.
PLUG UNIT INTO a 110-120 Volt outlet on a circuit with no less than a 20 amp breaker. When using
an extension cord, never use less than 12 gauge wire. Runs of over 100 feet are not recommended.
Excessive voltage drop at the unit will cause the motor to burn out.
IF A 220 VOLT UNIT WAS ORDERED connect wire to a 220-240 volt, 50/60 cycle, 1 phase power
source. Unit will draw approximately 8 amps. Make certain wiring is sized properly. Excessive
voltage drop at the unit will cause the motor to burn out.
1. GENERATOR MUST BE 5000 WATTS OR LARGER. Disable idle down feature so generator
engine is running at operating speed before turning on machine.
2. TURN ON using the toggle switch.
machine on and allow oil to warm up for 5 to 10 minutes before using.
3. ALWAYS TURN OFF when not in use. DO NOT run unused for long periods of time.
4. KEEP IN UPRIGHT POSITION to prevent loss of hydraulic oil from the oil tank breather cap.
5. DO NOT DROP machine as serious personal injury may result and damage to the
machine is likely.
6. PICK UP OR CARRY machine using a forklift or loader.
Utilize the lifting tubes welded to the bottom of the frame.
OPERATION
In cold weather operations (below 32 degrees F), turn
Advertisement
Table of Contents
