Advertisement
Before the first time you use your DAB Radio
Please read these operating instructions thoroughly and keep them in a safe place for future reference.
Remove all packing materials and discard responsibly.
Fitting the Lanyard (1)
This radio is supplied with a Lanyard, the fitting procedure is as follows:
Thread the small cord loop through the mounting hole at the top left corner of the radio, then thread
the handle of the Lanyard through the cord loop to secure it into place.
Before first using your DAB/FM Radio ensure it is fully charged as follows:
1. Insert the Micro USB Plug (20) of the USB Charging Cable (19) into the Micro USB Charging Port
(12) on the right-hand side of the radio (arrowed below). The red Charging LED (13) will
illuminate.
2. Connect the USB Charging Cable (19) into a suitable USB charger rated at 1 Amp. NB using a
charger rated at higher than 1 amp may damage the battery and/or the radio.
3. The internal battery of the radio will now charge, from a flat battery this will take approximately 4
hours. The red Charging LED (13) will go out to show the battery is fully charged.
NB to check the status of the battery charge, first remove the USB Charging Cable (19), press the
INFO/MENU button (4) until the battery charging information is shown as below as a percentage:
Left Arrowed:
The Micro USB Charging Port
5
Advertisement
