Vcr And Cable Box - Sony KV-36HS510 Operating Instructions (primary manual) Operating Instructions Manual

VCR and Cable Box

Using
S VIDEO jacks?
See page 21.
24
For best results, use this connection if:
❑
Your cable company scrambles some channels, such as premium
channels (which requires you to use a cable box), but does not
scramble all channels.
About Using Twin View with This Connection
With this connection, you can use all the features of Twin View. For details about Twin
View, see page 46.
With this connection you can:
❑
Use the TV remote control to change channels coming through
the cable box. (You must first program the remote control for
your specific cable box; see "Programming the Remote Control"
on page 43.)
❑
Use the TV remote control to change channels coming directly
into the TV's VHF/UHF jack. (The TV's tuner provides a better
signal than the cable box.)
❑
Record channels coming through the cable box and channels
coming directly into the TV.
To connect a VCR and cable box, you need:
❑
A splitter, which is a small, inexpensive device that you can
purchase at your local electronics store.
✍
DIGITAL CABLE BOX USERS: If you are connecting a digital cable
box, you will need a special bi-directional splitter that is designed
to work with your digital cable box. Contact your cable provider for
details.
❑
Three coaxial cables.
❑
One A/V cable or one S VIDEO cable with audio cables.
To connect the VCR and cable box
1
Connect the CATV cable to the single (input) jack of the splitter.
2
Use a coaxial cable to connect one of the splitter's two output
jacks to the TV's VHF/UHF jack.
3
Use a coaxial cable to connect the splitter's other output jack to
the cable box's input jack.
4
Use a coaxial cable to connect the cable box's output jack to the
VCR's RF input jack.
5
Use an A/V cable to connect the VCR's A/V output jacks to the
TV's A/V input jacks.
6
Run the Auto Setup program, as described in "Setting Up the
Channel List" on page 38.