Remote Control - Sony KV-36HS510 Operating Instructions (primary manual) Operating Instructions Manual

Remote Control

Problem
Remote control
does not operate
Cannot change channels
with the remote control
Remote control
does not operate non-Sony
video equipment
Channels
Problem
Cannot receive upper
channels (UHF) when
using an antenna
TV is fixed to one channel
Cannot receive any
channels when using
cable TV
Cannot receive or select
channels
Possible Remedies
❏
The batteries could be weak. Replace the batteries.
❏
Check the orientation of the batteries.
❏
Press the TV FUNCTION
SAT/CABLE FUNCTION
CABLE mode.
❏
Make sure the TV's power cord is connected securely to the wall outlet.
❏
Locate the TV at least 3-4 feet away from fluorescent lights.
❏
If you are using the TV to change channels, first press the
button.
❏
If you are using another device to change channels, be sure you have not
inadvertently switched your TV from the channel 3 or 4 setting. Use the
Channel Fix
option to "fix" the channel based on the hookup you used (see
page 68).
❏
If you are using another device to change channels, be sure to press the
FUNCTION button for that device. For example, if you are using your cable box
to change channels, be sure to press the
❏
If you replaced the batteries to the remote recently, the code numbers for
the video equipment may need to be reset.
❏
There may be more than one code for the equipment that you are
attempting to operate.
❏
There is a possibility that some non-Sony equipment cannot be operated by
your Sony TV remote.You may need to use the equipment's original
remote control.
Possible Remedies
❏
Change the Cable option to
❏
Use Auto Program in the Channel Menu to add receivable channels that are
not presently in the TV's memory (see page 68).
❏
Auto Program
Use in the Channel Menu to add receivable channels that are
not presently in the TV's memory (see page 68).
❏
Check your Channel Fix settings (see page 68).
❏
Use Auto Program in the Channel Menu to add receivable channels that are
not presently in the TV's memory (see page 68).
❏
Make sure the Cable
❏
Auto Program
Use in the Channel Menu to add receivable TV channels that
are not presently in TV memory (see page 68).
button. You may have inadvertently pressed the
button, which changes the remote control to SAT or
SAT/CABLE FUNCTION
Off (see page 68).
option is set to On in the Channel Menu (see page 68).
TV FUNCTION
button.
81