Advertisement
WARNING
ANY RAPID UP-SCALE READING FOL-
LOWED BY A DECLINING OR ERRATIC
READING MAY INDICATE A GAS CONCEN-
TRATION BEYOND UPPER SCALE LIMIT,
WHICH MAY BE HAZARDOUS.
TOUTE LECTURE RAPIDE ET POSITIVE,
SUIVE D'UNE BAISSE SUBITE AU
ERRATIQUE DE LA VALEUR, PEUT
INDIQUER UNE CONCENTRATION DE GAZ
HORS GAMME DE DÉTECTION QUI PEUT
ÊTRE DANGEREUSE.
WARNING
To reduce the risk of ignition of hazardous atmo-
spheres, recharge, remove, or replace the battery or
sensors only in an area known to be non-hazardous!
Equipment which is intended for use in explosive
atmospheres and which has been assessed and
certified according to international regulations may
be used only under specified conditions. The
components may not be modified in any way.
The appropriate regulations for service and repair
must be properly observed during such activities.
This instrument contains a connector for mounting
of a wind sensor – RAEMet. This connector has a
set of entity parameters that match the input entity
parameters of RAEMet:
Uo: 5.2V; Po: 0.788W; Lo: 198μH; Co: 1000μF.
The solid-state relay connection is supplied with
following entity parameters, that must be complied
with for external connections: Ui: 24V; Ii: 250mA.
ONLY THE COMBUSTIBLE GAS DETECTION
PORTION OF THIS INSTRUMENT HAS BEEN
ASSESSED FOR PERFORMANCE.
UNIQUMENT, LA PORTION POUR
DÉTECTOR LES GAZ COMBUSTIBLES DE
CET INSTRUMENT A ÉTÉ ÉVALUÉE.
CAUTION: HIGH OFF-SCALE READINGS
MAY INDICATE AN EXPLOSIVE
CONCENTRATION.
ATTENTION: DES LECTURES HAUTES ET
HORS D'ECHELLE PEUVENT INDIQUER
DES CONCENTRATIONS DE GAZ
INFLAMMABLES.
CAUTION: SUBSTITUTION OF COMPO-
NENTS MAY IMPAIR INTRINSIC SAFETY.
Keep all ports covered when they are not in use.
This keeps moisture and debris out of the ports and
contributes to the instrument's intrinsic safety.
Note: Users are recommended to refer to ISA-
RP12.13, Part II-1987 for general information on
installation, operation, and maintenance of
combustible gas detection instruments.
The AreaRAE Plus/Pro multi-gas monitor must be
calibrated if it does not pass a bump test, or at least
once every 180 days, depending on use and sensor
exposure to poisons and contaminants.
CAUTION: BEFORE EACH DAY'S USAGE,
SENSITIVITY OF THE LEL SENSOR MUST BE
TESTED ON A KNOWN CONCENTRATION OF
METHANE GAS EQUIVALENT TO 20 TO 50% OF
FULL-SCALE CONCENTRATION. ACCURACY
MUST BE WITHIN 0 AND +20% OF ACTUAL.
ACCURACY MAY BE CORRECTED BY
CALIBRATION PROCEDURE.
ATTENTION: AVANT CHAQUE UTILISATION
JOURNALIERE, VERIFIER LA SENSIBILITE DU
CAPTEUR DE LIE AVEC UNE CONCENTRATION
CONNUE DE METHANE EQUIVALENTE DE 20
A 50% DE LA PLEINE ECHELLE. LA PRECISION
DOIT ETRE COMPRISE ENTRE 0 ET 20% DE LA
VALEUR VRAIE ET PEUT ETRE CORRIGEE PAR
UNE PROCEDURE D'ETALONNAGE.
FCC Part 15 Compliance
This device complies with Part 15 of the FCC
Rules / Industry Canada license-exempt RSS
standard(s). Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
25.
24.
26.
Rev B July 2017
P/N: W01-4012-000
Advertisement
