Table of Contents
Advertisement
Step 3: Attach Top Support Plate
Hardware Needed:
Qty 1: Elbow Support Part #24)
Qty 1: Bolt M10 (Part #1)
Qty 1: Ф10 spring washer (Part #2)
Qty 3: Ф10 washer (Part #3)
Qty 1: Bolt M10X60 (Part #4)
Qty 4: Plastic (Part #5)
Qty 1: Nut M10 (Part #8)
Qty 1: "W" Plate (Part #19)
Note that the "W" Plate (Part #19)and plastic (Part #5) are pre-assembled. Next place "W" plate
onto the elbow support (Part #24). Attach the elbow support (Part #24) onto bottom (under) center
support (Part #21) using M10X60 bolt (Part #4), M10 nut (Part #8) and two washers (Part #3). See
below.
Page of 11
5
Advertisement
Table of Contents
