Table of Contents
Advertisement
Qty 1: Pin (Part #16)
Qty 1: "R" Pin (Part #17)
See figure#1 below. Attach turn elbow plate (Part #22) onto hitch base (Part #23) using M16X75 bolt,
M16 nut and washer (see specific hole location below). Next, insert Pin (Part #16) to the second
hole (see below) using "R" pin and washer to secure it.
Step 2: Attach bottom support to turn plate from step 1.
Hardware Needed:
Qty 1: Center support (Part #21)
Qty 2: Bolt M12X75 (Part #9)
Qty 2: Ф12 washer (Part #10)
Qty 2: Nut M12 (Part #11)
See figure #2 below. Attach under support into the turn plate using M12X75 bolt, M12 nut and
washer.
Page of 11
4
Advertisement
Table of Contents
