Advertisement
4. Indicating elements
The indicating elements are located at the front of the appliance.
They enable the operator to monitor the water quality ("Purity level I, II and III") during the water
purification process and also serve to display error messages.
If an error message occurs, contact the Winterhalter after-sales service and quote the displayed error
message.
Your appliance is working normally if the indicator for purity level II or III lights up no later than 2 minutes
after the commencement of water purification. If the indicator for purity level I lights up, this means that the
water quality has deteriorated.
The system then switches automatically to fault status (see error messages) and stops the purification
process.
5. Operating the appliance
Once your RoMatik 150 has been installed and calibrated by the Winterhalter service technician, it is ready
to be put into operation.
The RoMatik 150 is equipped with an electronic control system in order to simplify operation. During
normal operation, there are only a few points to be observed:
Observe indicating elements for the purity level in order to detect any deterioration in the water quality
at an early stage. This will also affect the washing results of your dishwasher.
Observe error messages in order to be able to notify the Winterhalter after-sales service in time and
so avoid damage to the appliance.
After producing purified water continuously for 15 minutes, the appliance automatically performs a
flushing cycle. This is not an error.
6. Caring for the appliance
Only use a damp cloth and no other cleaning agents on the RoMatik 150. Do not rinse the appliance
with water.
Check all water connections regularly. Condensation beneath the filter behind the front cover is not a
sign of leakage, and can be simply wiped dry. If the "stop" indicator lights up due to an accumulation of
condensation, remove the mains plug after wiping and wait for 2 minutes before plugging it in again.
Check the indicating elements regularly for error messages.
89005232-05
03/12 sch
on/off
filter I
stop
calibration
Kalibriertaste
Winterhalter Gastronom GmbH
Tettnanger Str. 72
D-88070 Meckenbeuren
filter II
purification level
Reinheitsgrad
I
II
III
3
Advertisement
